Sign In
You're All Set
Welcome back! You are now signed in.
You have been logged out
You have been logged out due to inactivity
Forgot Password
Please enter the email address you used to create the account. We'll send you a link that lets you create a new password.
You're All Set
Please check your email. Click the link in the email to create a new password.
Reset Password
You're All Set
Success! Your password has been updated.
Change Password
You're All Set
Success! Your password has been updated.
UL U336
Area Separation Wall - Wood Stud (Non-Load-Bearing)
| Fire Rating | 2 hours |
| System STC | 54-58 |
| System Thickness | 6.75 in. |
Assembly Construction
Assembly Construction
Layer 1 - Gypsum Panel:
1 layer 1/2" [12.7 mm] Sheetrock® Ultralight Gypsum Panel
Layer 2 - Gypsum Panel:
1 layer 1/2" [12.7 mm] Sheetrock® Ultralight Gypsum Panel
Layer 3 - Wood Studs:
1 layer 2" x 4" [38 x 89 mm] Wood Studs, 24" [610 mm] O.C.
Layer 4 - Insulation:
1 layer 3" [76 mm] Fiberglass insulation
Layer 5 - Air Space:
1 layer 3/4" [19 mm] air space
Layer 6 - Steel Studs:
1 layer 2" [51 mm] H-studs, 24" [610 mm] O.C.
Layer 7 - Steel Studs:
1 layer 2" [51 mm] H-studs, 24" [610 mm] O.C.
Layer 8 - Gypsum Panel:
1 layer 1" [25.4 mm] Sheetrock® Gypsum Liner Panels (UL Type SLX)
Layer 9 - Gypsum Panel:
1 layer 1" [25.4 mm] Sheetrock® Gypsum Liner Panels (UL Type SLX)
Layer 10 - Gypsum Panel:
1 layer 1" [25.4 mm] Sheetrock® Gypsum Liner Panels (UL Type SLX)
Notes
- For the most up-to-date details, including construction variations, refer to the published assembly in the UL Product IQ™ database or GA Design Manual.
- Stud sizes and insulation thickness are minimum unless otherwise stated in the published assembly.
- Stud and fastener spacings are maximum unless otherwise stated in the published assembly.
- Panel orientation shall be as specified in the published assembly.
- Refer to applicable codes requirements to ensure compliance prior to construction.
- Where acoustical performance is provided in an estimated range, the values are based on laboratory test data of similarly constructed assemblies.
- Where design no. indicates “per”, the fire rating is based on laboratory test data of the referenced similarly constructed assemblies.